![]() All you have to do is to reach out to the dealer and explain the situation. You can also try your luck with the warranty-claiming routine. So, if the circuitry is in poor shape and you can see visible damage, it is time to get a new one. There is no point in making use of a broken or damaged lock. From there, you need to check the lock for damage. There is a possibility that someone was trying to break into your house, and you should call the authorities if that is the case.Įven if the burglar was unsuccessful, you need to report the event as that will alert the officials. Hardware issues with the unit can also lead to a similar situation where you won’t be able to secure any response from the beeping system. S o, be sure to get fresh ones if you’re in this situation. There is no point in going cheap, and weaker batteries will create more problems down the road. Lastly, if the batteries have not been changed in a while, now might be a good time to get new ones. It will only take a few moments at max, and then you can go through the basic setup one more time. So, all that you need to do here is to adjust the system by fixing the response from the unit. It will take a few moments at max, and you will notice a better response from the unit. ![]() So, if you’re sure that everything is well on your end and there are no signs of damage, then power cycle the unit. This power cycling routine is also effective when it comes to addressing minor issues with the lock beeping. So, be sure to keep that in mind and clean up the connectors first. You won’t have to rely on any extensive routines or troubleshooting methods to get through the fix. Most of the time, just removing and reinserting the batteries after cleaning the connection points a bit will do the trick. So, if you’re in a situation with weak batteries or corroded wire connections, try replacing the batteries. You will struggle with errors when the power connection to the system is not optimal. ![]() Sometimes, all it takes on your end is to reinstall the batteries in the unit to further isolate the problem. You always have the option of using the programming code to disable the beeper manually if you’d like. However, if the beeping noise is still coming from the lock, then you can try resetting the lock and pairing it again with your application. You will find the option at the bottom of the security tab.Īfter the beeper is turned off, try using the lock again to check if everything is in order. From there, go to security settings and toggle off the beeper option. You can select the lock that you want to configure and then go into the lock settings. If you don’t want to bother disabling the beeper by using the programming code directly, then try going into the Schlage mobile application and disabling the beeper from there. So, it is better to leave it on if you don’t get annoyed too much by the beeping noise coming from the lock every time you try to open it. The purpose of the beeper is to alert users whenever someone uses the keypad to open the lock. If, for some reason, you want to enable the beeper again, then follow the same procedure, and the beeper will toggle on. That will disable the beeper on your lock and, as confirmation, will see the green LED indicator go off twice. Now, you will just need to put the programming code into the lock and press the number 5 on the keypad.
0 Comments
Leave a Reply. |